air over hydraulic

ANVER

Home › Forums › air over hydraulic

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 25, 2020 at 10:10 am #20967
    admin
    Participant

    This press would operate at 10,000 PSI to meet the 100 Ton requirement. This is a common pressure for hydraulic circuits powered by an ENERPAC or OWATONA high pressure setup. Both oof these companies make Shop Presses. As for stroke it depends on the type of Air-Oil pump. Both of the aforementioned companies make reciprocaing intensifiers that would allow for a continuous pressure for the full stroke. However, it will not be a fast stroke, in fact it willl probably be very slooooow.

    November 25, 2020 at 10:10 am #20968
    admin
    Participant

    Bud: Thank you for the help on my press question. You helped me tremendously. It seems like I could convert it to an electric pump if it turns out to be too slow. The Enerpac designs are twice as fast with electric pumps.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.