Question on flow control orientation and valve type

ANVER

Home › Forums › Question on flow control orientation and valve type

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 26, 2020 at 9:03 am #21068
    admin
    Participant

    One way to stop the motion of the clamps is to use a blocked center valve but remember that air is compressible and there will be some movement at the center position. Plus, there will be air trapped in the system which is a e-stop no-no. Try to

    November 26, 2020 at 9:03 am #21069
    admin
    Participant

    Rick,The type of valve is dependent on the application. If you are attempting to hold the clamped position” then a closed center valve is best. However

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.