Davelfc64
Forum Replies Created
- AuthorPosts
- December 5, 2020 at 12:04 pm in reply to: Having trouble finding info on creating pneumatic schematics #21517
adminParticipantI use Festo FluidDraw V4.It’s great!Only buy it from Festo USA as they charge for the CD. I almost bought a copy in Canada however, they wanted 8 CDN for the same thing. It exports .dxfs well and it’s generic for use.
December 5, 2020 at 12:04 pm in reply to: Having trouble finding info on creating pneumatic schematics #21518adminParticipantYou should try Automation StudioI am using this software since version 2 and i find it the best solution to make circuit.here is there web site http://www.automationstudio.com
adminParticipantYou will need to use a relieving regulator. Depending on the load variations and times, the regulator will exhaust excess pressure when the load is increased. When the load is decreased the pressure will fill to compensate. If you use a non-rel
adminParticipantHi Jeromy,Thanks for the reply. From your advice I came up with the following:http://members.rogers.com/afeudale34/airsus.jpgA relieving electronic regulator sets the pressure, then to apply it to the cylinders, you toggle the solenoid valve. Th
adminParticipantThe 5/3 valve is going to dump from the front while adding to the rear. If the pressure is higher in the cylinders then at the regulator when you energize this valve, the front will dump while the rear will back flow to the regulator. I think yo
adminParticipantHi Eric,Sorry..I forgot to mention port 3 and 5 (the two exhaust ports) on the 5/3 valve will have threaded air blocks”
December 5, 2020 at 12:06 pm in reply to: Looking for cheap diaphragm air pumps for toy mftre #21523adminParticipantNeed the same size to be on a emergency airsupply unit.retained your info and will send you what I find.4/9/03Good LuckMartin Kinney
adminParticipantIf still of interest please indicate:- electric or pneumatic operated- port size needed in the sub-base- quantity neededWe might have the needed valve.
adminParticipantIMI NORGREN Will have all the fittings you need
adminParticipantYou can’t get tastier than ours! Prices I meanPlease call FM
adminParticipantFor you my friend, the fittings will be almost free….However, the freight will be very expensive…
adminParticipantRich:I currently may have a use for that controller. Please email me at economic56@earthlink.net.
adminParticipantCall Horton Hydraulics918-836-8045.
adminParticipantPick up any pneumatic tubing catalog.
adminParticipantI found out its O.D.E. instead of DOE. I still need an american contact or something similar.
- AuthorPosts
