Davelfc64
Forum Replies Created
- AuthorPosts
adminParticipantWhat voltage pump do you need?What country are you in?I will give you a company name near you that makes this kind of pump.
adminParticipantYou should always initialize the process using a two hand anti tie down (THATD) as mentioned in an earlier thread. The THATD occupies both operator’s hands during the complete process or only initially during the start of the process.The drawback
adminParticipantTry Compair when it comes to jackhammers
adminParticipantWayne’Try http://www.doering.comBud Trinkel
adminParticipantWhat valve are you using: cartridge or manifold? What are you using it for? What is expensive?
adminParticipanttry http://www.haskel.com , they have these valves
adminParticipantDave;A high pressure Air-Oil circuit normally uses air-oil tanks for fast approach and retract at low (air) pressure and an Air-Oil Intensifier for the high pressure work stroke. Air pressure forces oil from the air-oil tanks into the cylinder fo
adminParticipantI agree with what Bud says above; however, I would like to add a couple things.The most common circuit uses an oil reservoir connected into the pressure side of the intensifier. Commonly, there is either a pressure switch or a position limit swit
adminParticipantI agree with what Bud says above; however, I would like to add a couple things.The most common circuit uses an oil reservoir connected into the pressure side of the intensifier. Commonly, there is either a pressure switch or a position limit swit
adminParticipantWow! How finite does the circuit have to be? To the OSHA requirements of .3 seconds? Or just a basic two hand anti tie down? In any event, it is an interesting project. Anyway, there are several methods. It has been about 7 years since I hav
adminParticipantPhyllis; You don’t say how fast you need the info. I have a Power Point presentation on Air Logic that covers the logic components and an Anti Tie Down circuit plus other common air logic circuits. It is 7.5 megs and takes a long time to email bu
adminParticipantBud & Phyllis: This is a lot of stuff. I realized the question was about building a THATD; however, I think it is very important to understand why I use these components. So you understand my background, I started using the old ARO blocks and m
adminParticipantOne item that does not come up is what happens if a button or spool sticks? Picture an operator putting the part in place with their right hand as always, pushing both buttons, the part isn’t in correctly so they let go of the palm button and rea
adminParticipantEric, First, I am no expert in machine guarding and safety. JointAir does not currently sell safety equipment. That being said, there are many electronic THATD controls which replace the air logic style.Banner is probably the best known manufact
adminParticipantWHAT IS THE MIN AND MAX DISTANCE REQUIREMENT BETWEEN THE TWO HAND CONTROL? ALSO THE MIN AND MAX HEIGHT SPECS.THANKSRUSS JOHNSON
- AuthorPosts
