[admin]

You can use a Spool type valve to stop flow both directions. However, many Spool type valves have some bypass when closed so they stop flow but not completely. You could look at MAC or NuMatics spool types and even use a 3 or 4-way and plug the extra ports if there is no 2-way available.

[admin]

Try the Norgren valve M/1338 or M/738 2/2 pilot/spring poppet valves. They are 1/2″ & 3/4″ BSP ported valves respectively. Remember to pipe them for oil from port 2 to 1 (in reverse).

[admin]

2WC Series Normal Open General Solenoid Valve Tecnology Parameter Operating Medium: Air,Water,Oil,Gas Motion Pattern: Direct Drive Type Type: Diaphragm Type,Normal Open Operation Fluid Viscosity: 20CS Below Pressure Difference: 0~1.0Mpa Working Pressure: 1.0Mpa Medium Temperature: -5~80¡æ Install Method: Wantonly Voltage: AC380V£¬220V£¬110V£¬36V£¬24V,DC220V£¬110V£¬36V£¬24V£¬12V Port Size: G1/2¡±, G3/4¡±, G1¡±, G11/4¡±, G11/2¡±, G2¡±

[admin]

This is a Compair part number for a logic base. Try a Compair or Watts distributor.

[admin]

IPEC automation phone# 905-738-6688 or 1-866-665-7877 fax 905-738-6251

[admin]

check out norgren they are own herion

[admin]

Talk to Norgren norgren own herion

[admin]

Contact Norgren at http://www.norgren.com

[admin]

look at Norgren web site

[admin]

Dear sir We requir Pneumatic cylinder make martonair modal.M/6025/25 For vashi Engineers Tarun

[admin]

I ordered an air cylinder from them a few weeks ago. You can configure just about any NFPA or round cylinder you like. I questioned the quality, but they seem to be made as well as any I’ve seen. What sold me was their prices though. They were cheaper than anyone I compared to. I’ll definately buy again from them.

[admin]

The ANSI info I have does not show a symbol for a Pressure Transducer. However, ISO does have one. I could send you an MSWord .doc of one if I had your Email address. You can also purchase the ISO Symbols at http://www.iso.org/iso/en/CombinedQueryResult.CombinedQueryResult?queryString=fluid+power+symbols and http://www.iso.org/iso/en/CombinedQueryResult.CombinedQueryResult?queryString=1219-2 If these links do not work got to http://www.iso.org and search for 1219-1 and 1219-2 to get the full info on Fluid Power symbols. There is a cost to download the symbols.

[admin]

Dear Sir, It might be from Parker Hannifin.I believe its for high pressure hydraulic oil.Mail me if you are interested.

[admin]

Did you have any luck sourcing IWN coils? i am in the same boat and would be grateful if you have found a supplier to let me have thier number. cheers

[admin]

Hi, did you manage solve your problem? If not, please email me the drawing/picture/photo. We try to solve your problem.

[Author]

Posts