[admin]

Contact me.00421 51 74 80 464www.regada.sk

[admin]

Purpose of volume booster is to provide higher volume of output to the control valve, which in some cases, the positioner cannot cater.In your case the booster relay is to be connected in between positioner out put and control valve.Then the valve

[admin]

Sounds like a Telemechanique part. I’m here all the time and usually works out great for me.Good luck…

[admin]

It´s a Telemechanique part but Parker bought this part so today it is a part of Parker pneumatics

[admin]

hey send me an email i might ave a pdf for u on the switches, just found some stuff on the web

[admin]

Which area are you looking for?

[admin]

Try Hargraves or Reitchel Thomas.

[admin]

Try Humphrey Products, they only have a 1/4 valve for glue but you could start with them.#R332http://www.humphrey-products.com

[admin]

How about an over center toggle mechanism? They usually produce up to 10 times the power of a standard linear thrust.

[admin]

Darell;I take it you are using Flow Controls in a Meter Out orientation. If so use regulated air at a pressure that is always available to the valve that operates the low weight end of the roll. Most plant air systems fluctuate throughout the day

[admin]

Darrell;The circuit would work best if both cylinders had equal pressure on the raise side of the cylinders and variable pressure on the lowering sides. The heavy load side would be somewhat lower pressure on the lower the rolls side. The light lo

[admin]

Do you have room to install a Rack & Gear assembly so that the roller can only raise or lower evenly?

[admin]

Please, contact me.We are a producer of pneumatic cylinders.T: 00421 51 74 80 464www.regada.sk

[admin]

This is an old pneumatic sequencer. The trimmer portion was to regulate the speed of the indexing. I don’t think it is available anymore.

[admin]

An impact wrench is working mechanically and is mainly used simply to close or open a screw. An impulse tool uses a medium (oil). Therefore the impulse tool is hammering smoother” and the tolerances are less (+-30% for impact

[Author]

Posts